ZPure™ Gas Purifiers and Filters
An extensive range of convenient point-of-use purifiers with high sensitivity visual indicators for oxygen and water breakthrough
Note: Filter lifetime is dependent on quality of the incoming gas and the flow rate. For more detailed specifications on individual applications, please contact Greyhound at sales@greyhoundchrom.com |
Compression Fittings Seal well and can be broken and retightened many times if used properly. Compatible with industry standard ferrules and tubing. |
Quick Connect Fittings Used for fast connections and replacements. They have superior seals using O-rings and check valves to protect gas lines. |
ZPure C02 Stainless Steel Filters
ALSO AVAILABLE
ZPure™ LS H2O Filters for use with ASTM D6550 and ASTM D5186 using SFC
The H2O filter for use with ASTM D6550 and ASTM D5186 using SFC
The ZPure H2O Filter removes moisture from inert gases, He, Ar, N2, H2, methane and clean dry air (CDA) to low ppb levels, with very high capacity. It is recommended for any application that requires ultra-dry gas, and is available in 130cc and 475cc stainless steel cylinders with standard 1/4” and 1/8” brass and stainless steel compression fittings.
ASTM D6550 and ASTM D5186 using Supercritical Fluid Chromatography has been approved as an alternative to FIA ASTM D1319 standard test method for Hydrocarbon Types in Liquid Petroleum Products. This filter was manufactured with molecular sieve 3A by customer request for use with a Supercritical Fluid Chromatograph.
Moisture Removal for Specialized Applications
- CO2 purification for SFC - In the petroleum industry, both the Environmental Protection Agency (EPA) and California Air Resources Board (CARB) have approved ASTM D6550 and ASTM D5186 for final product release of gasoline and diesel fuels. In this type of application, the reduced heating of 3A is expected to reduce desorption of already bound moisture, protecting sensitive and expensive columns.
- Mixed source gas - Purifiers should not be used to remove water from individual gas samples intended for analysis; some proportionation may occur. Gas purifiers typically use either molecular sieve 5A or 13X adsorbents to remove water from gas streams. These are beneficial for carrier gases used with GC or GC/MS, because in addition to water they also remove many other common contaminants. (“5” and “13” refer to the adsorbent’s pore diameter in angstroms.) In some applications, however, 3A molecular sieve with smaller pore size may be preferred. It removes water yet excludes almost all larger molecules including CO2, the carrier used in Supercritical Fluid Chromatography (SFC). Since CO2 is excluded there is no significant temperature rise on installation, due to heat of adsorption, which may occur with 5A or 13X purifiers.
ZPure LS H2O Filter, 130cc, 1/8" S/S Compression Fittings, with Molecular Sieve 3A |
|
ZPure LS H2O Filter, 475cc, 1/8" S/S Compression Fittings, with Molecular Sieve 3A |
|
ZPure LS H2O Filter, 475cc, 1/4" Brass Compression Fittings, with Molecular Sieve 3A |
|
ZPure LS H2O Filter, 475cc, 1/4" S/S Compression Fittings, with Molecular Sieve 3A |
|
CONTACT US
Tel: +44 (0) 151 649 4000
Email: marketing@greyhoundchrom.com
FOLLOW US
YOU MAY ALSO BE INTERESTED IN OUR NEWSLETTER